Bottom of saddle tree shown. Existing billet hangers are lowest ones attached to points of tree. New hangers installed are middle ones placing front billet behind the thigh block.
After: Girth now aligns properly for horse conformation. Shoulder is now free. Note the hole at the bottom of the thigh block where the old point billet was previously aligned.
In this monoflap saddle, the billets are passed through the center of the single flap. This photo shows the two billet hangers coming off the tree and entering the top of the flap. The rear hanger shown is standard from the factory, and the front hanger shown was installed at the new location behind the thigh block by Advanced Equine Saddle Fit.
RSS Feed
